Structural Rolling
Your Source for Structural Rolling
For over 20 years, VeriForm has been providing rolling structural tubing, piping and solid bars. Our expert team has only the highest precision Italian rolling equipment, allowing you to have full confidence that your structural rolled parts will be on spec and perform as intended every time. We can even roll metals up to 10 feet wide!
We can roll:
- Bars
- Channels, T-Beam, H-Beam
- Angles
- Tubes
- Pipes
- And Much More!
Here is a stack of 6-inch structural steel channels rolled with the legs inside. In the background, you can see metal skins also rolled at VeriForm.
Small flat bar clamps rolled from half-inch steel and also a bend at each end. The units are about 1 foot high with a 6-inch radius.
An excellent example of small to large 180 degrees rolled sections from 1/2 inch steel with holes and then 90 degree bends to make clamping structures for a very large project in the gas sector.
Assorted crimping and pipe rolling-bending of different railing and handles from 1-inch steel pipe-tubing.
Here is a complete 1 piece railing by VeriForm made from a 1-inch diameter steel pipe for a man lift.
